Get Your Dd-Wrt Wireless Router Bridge Linksys 160N And Wrt54gs

The purpose of this application is to explain how the router Teltonika RUT104 HSUPA 3G with the HWg field of remote monitoring over IP devices, such as remote monitoring network / GPRS can be performed 3G to configure itself to work.

We must ensure that the router before you proceed is correct configured. Your router must delay. Check your LAN IP configuration found router in your web connection. If you are not sure how to connect to your router, it should say in the manual. You will probably see something like 192.168.1.1 or 10.0.0.1. As to why, I think, your default settings of the router to 10.0.0.1 and your subnet mask is 255.255.255.0. If you do otherwise, you can leave it that way. Remember, just replace in the future configuration, when I talk about 192.168.1, with 10.0.0. For now that’s all we need to do with the router.

Once you might have the type of encryption and key set to the router, disconnect from this router. Now connect to the router WRT54G DD-WRT modded, then go to the Configuration tab and change the indigenous community to 10.0.1.zero or vary any forms of community that you prefer.

Right-click on the LAN that corresponds to your Ethernet adapter. If you have a wireless adapter, you will see two. Select the LAN connection, or one that is permanently connected to the network. Select Properties.

An unsecured wireless network allows anyone to use within the reach of your Internet connection, which slows your personal connection and possibly to drive your internet bill. And if people start to use your Internet connection for illegal means, you will likely be included in any resulting investigation.

We simply let DHCP do the work for us to perform. Connect the two with an Ethernet cable and reboot. DHCP automatically assign magically a computer’s IP address, which will make it possible to connect the router.

You can set up, configure printers, game consoles, and almost all other wireless devices, without assistance if you understand how to configure a wireless router properly.

Now that you have your DHCP setup, you can use it. The computers that will join the network’s IP address, starting with 192.168.1.11 and 192.168.1.254 all the way up automatically. The 10 IP addresses, which will be excluded for other network server that a static IP address or to have one that does not change.

Ensure that all static IP addresses already assigned not ruled fall outside the range of addresses. Otherwise, it is quite possible that they could be duplicate IP addresses, which can cause strange network failure.